*PLEASE READ -- The decal is covered with a clear “application tape” that allows you to transfer the decal to the application surface. To make sure the decal will stick to the application tape (and not the paper), apply pressure to the entire decal using a squeegee, credit card, plastic spatula or your finger.

Thoroughly clean the area where the decal is to be applied using a non oil based cleaner; warm soapy water works fine. Allow time to dry.  You may wish to use rubbing alcohol on the application surface to make sure that it is cleaned of all chemicals.

Trim around the decal if necessary using scissors or an Exacto knife. Make sure to use the decal itself to center or level the decal since the application tape may not be perfectly cut. Be careful not to cut the decal or YOURSELF!

Peel the paper backing off. This is done easiest by placing the decal FACE DOWN on a flat surface.  Then peel the paper backing off making sure the decal sticks to the application tape that is on the front of the decal.

Position the decal where you would like to place it. Be sure to level the DECAL since the application tape may not be level with the decal. DO NOT use any pressure yet. If the decal is not level, centered, etc. you may reposition it if you have not applied pressure.

Once the decal is where you want it, apply pressure to all of the decal. You may use a squeegee or your fingers.  A credit card, plastic spatula or something similar will work in place of a squeegee.

Now it is time to remove the application tape. Start at a corner and slowly pull back, PARALLEL to the surface. DO NOT pull away from the surface.

Helpful Tricks

If you have a 2 color/layered decal, wet installation can be used for the top layer for proper placement but is not required.  For a wet install simply spray down the the installation surface (decal that has already been installed) using a spray bottle filled with water and a VERY small amount of liquid soap.  Also spray down the backside of the decal you are installing as you remove the paper backing.  Now position the decal where you want it withOUT applying pressure.  Once it is aligned use a squeegee or equivalent to remove all the water.  After you have allowed the decal to dry (a heat gun or hair dryer speeds up the process) remove the application tape.

A heat gun or hair dryer can be use to “stretch” the decal around curved surfaces. Be careful not to overheat the decal as it can burn. This may be used in wet or dry installation.

Small bubbles can be squeegee’d to the edge of the decal. For larger bubbles you may use a pin to pop them and then apply pressure.

For extra durability clear fingernail polish can be added to the corners of the decal. This is highly recommended for decals that have small points (such as flames) or automotive (outdoor) decals.

Shadows are made by first applying the shadow color to the surface FIRST and then applying the main color slightly offset to the shadow color. Slightly above and to the left is the most popular but any variation looks great.